The modern way of plumbing now uses a vast choice of very good fittings and materials. The plastic type of fitting is a favourite choice for plumbing professionals. It will resist corrosion and will not succumb to lime scale build up especially if they are fitted in areas of hard water. Usually if connected to copper pipework, the copper will normally be the pipe you see. Dagenham Plumbers use all modern forms of plumbing materials. Cut a Plastic Pipe.There are specific cutters to make accurate cuts. There should always be an allowance made for the amount of pipe in the fitting. The cutter needs to be lined up with the next V marking on the pipe and then apply the pressure for the cutter jaws. Turn the pipe as you cut and you get a smooth finished cut. A Dagenham Plumber uses and cuts plastic pipework.Push Fit Fitting.There are many of this fitting type available, like straight connectors, elbows and Tee pieces. They have an internally fitted grabbing ring that gives a good solid fit on the pipework. The rings are quite sharp so care is to be taken not to put a finger in there. Always make sure there is no debris and dirt in the fitting as they will fail.Dismantle a Push Fit Fitting.This a very straightforward task and done with a product specific tool called a key. These are available for every standard pipe. The key is basically a collar that clips onto the pipework making sure that its flat side faces away from the fitting. This clip slides up to the fittings cap and when pushed the fitted lugs will cause the fitting to be released.